home › FAQ › Heating systems › Water heating

Questions on the heating project of a 12-story building

Kazbek

Topic created March 30, 2019

answer

236

views

There was a dispute over the project, about where should the transitions to a larger diameter stand? On floors where the diameter is indicated after tapping, or on the floor below, also after tapping on the feed system?

Attached Images:

Attachment Name Attachment Name

Visitors Comments

Expert
Alexey Dedyulin
Expert
To answer
Good afternoon, Kazbek. There is a golden rule - "So that there are no problems - do everything according to the drawing."
Attached photo is small resolution and clearly not visible. Plus, the nodes on your right are considered separately, as it should be in all projects. Therefore, it is correct to consider comprehensively, starting from two schemes.
I am sure that there is a snap on the axes, and focus on them. What is visually accessible without taking into account the consideration of explanations in the context, it is necessary to perform on floors where the diameter is indicated after the insert.

Add a comment