How to set up a direct-flow pump on an electronic relay?
1
answer136
viewsAssembled design on an electronic relay. When the tap is opened, the pump periodically turns on and off at regular intervals, that is, not constantly. What needs to be done so that the pump runs continuously and turns off only when the water is closed? Install an additional pressure switch, will this change the situation?
Attached Images:
Visitors Comments
Add a comment
How much does it cost to connect gas to a private house: the price of organizing gas supply 
The best washing machines with dryer: model rating and customer tips 
What is the color temperature of light and the nuances of choosing the temperature of the lamps to suit your needs 
Replacement of a geyser in an apartment: replacement paperwork + basic norms and requirements
Hello. You do not need to install an additional pressure switch, start by adjusting an existing pressure switch. This issue has already been considered in detail. here, plus in the discussions there are practical tips for adjusting the pump pressure switch. This should help, if not, then replacing the pressure switch with a more suitable one (but most likely that it will not be needed), and again adjusting for this manual.
I also highly recommend using a storage tank (hydraulic accumulator), so that in case of uneven supply of water from the well, you will not have problems with water supply. Even a 25 liter tank will be enough, but better with a 40 liter volume.
Another question for you: why is there a pan and a towel on the floor? If there are leaks, then I advise you to eliminate them, this should not be!